| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#18
07-22-2025, 12:30 PM
|
|||
|
|||
I have now removed all the rod bearings and pistons. It's almost the same on all of them.
I measured the crank play before I removed one of the main bearings. It showed 0.0078 inches. I have attached a picture of the bearing and crankshaft. I guess I have to order new main bearings also with new bolts.. I could not find any information on the cam, so I measured the height of the intake and exhaust cam to 0.275 inches. I have calculated the CR value as good as I can to 7.72:1 I have attached a photo of the data I have used. Thank you everybody. |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode