[Formulas]

Noooope... its on right.. There is another tell in plain view that has not been talked about yet..

[sportylemans]

Originally Posted by Formulas

Noooope... its on right.. There is another tell in plain view that has not been talked about yet..

Is it the second pic flexplate teeth where the starter engage?

[srmmmm]

Originally Posted by Formulas

Noooope... its on right.. There is another tell in plain view that has not been talked about yet..

I have seen a dimple on some factory ones that if mounted backwards, would create an obvious wobble appearance because the plate would be tilted on the crankshaft flange. But the angle cut on the teeth look like they're facing the wrong direction too.

[Gary H]

Originally Posted by srmmmm

I have seen a dimple on some factory ones that if mounted backwards, would create an obvious wobble appearance because the plate would be tilted on the crankshaft flange. But the angle cut on the teeth look like they're facing the wrong direction too.

A Pontiac flexplate can't be installed backwards. The bolt pattern won't allow you to get all 6 bolts in.

[johnta1]

I'm pretty sure you can only get one bolt in if backwards.

[zippy]

Originally Posted by Formulas

Noooope... its on right.. There is another tell in plain view that has not been talked about yet..

The bevel on ring gear