| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
01-10-2026, 04:16 PM
|
||||
|
||||
Even when I have a think bottom plate on my pump if I have a thin steel one from a 40 psi I sand / grind the notch off it and bolt it on to the top of thick plate.
I set up my pumps with .004” gear to plate clearance. I polish in a nice radius from the outlet of the gear cavity and I double pin the pickup tube to the pump body after making sure the lip of the pickup screen case is sitting on the cast locating lip on the side of the pump body.
__________________
Wernher Von Braun warned before his retirement from NASA back in 1972, that the next world war would be against the ETs! And he was not talking about 1/8 or 1/4 mile ETs! 1) 1940s 100% silver 4 cup tea server set. Two dry rotted 14 x 10 Micky Thompson slicks. 1) un-mailed in gift coupon from a 1972 box of corn flakes. Two pairs of brown leather flip flops, never seen more then 2 mph. Education is what your left with once you forget things! |
| The Following User Says Thank You to steve25 For This Useful Post: | ||
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
