| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
07-12-2026, 04:30 PM
|
|||
|
|||
Breakerless SE module kit on factory points distributor and coil
AFAIK, it should be 8-9v at the coil when running |
|
#2
07-13-2026, 04:21 AM
|
||||
|
||||
|
Ok, this unit is to be run with the original ignition harness including the resistor wire.
About 11 volts at coil + running is perfectly fine and whats to be expected using the resistor wire and an original 2.0 Ohm coil. Remember, the resistor wire reduces current as well as voltage. |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
