[Verdoro 68]

Original PCB - they just cleaned it up and resoldered it in places. I spent the money I saved on a the trans rebuild on the gauges. They cost me just as much as when Pete Serio did the rally setup for the '68. I was impressed that they turned the set around in a week in a half.

[Shiny]

They cleaned all the copper nicely and the soldermask is in great shape.

If this is for a connector, I'm curious what style mates with this? Reminds me of an old tube socket...

[Verdoro 68]

That's the connector for the dash harness. It's a horrible design .

[GT182]

Nice looking Javelin. And I love the color of it too.
A guy I went to high school with was given a 68 AMX as a 1968 graduation gift from his dad, an AMC dealer. Color, AMC Orange.
No he doesn't have it. I saw him at our 50th Class Reunion and he said he'd sold it. And called himself a dumbass.

[Shiny]

Originally Posted by Verdoro 68

That's the connector for the dash harness. It's a horrible design .

Thanks for the photo.

Not sure it's horrible but it is different...

[Verdoro 68]

It looks easier to plug in than it is. The sockets have a tendency to slip out of the connector and you have to have it clocked just right. The flat GM plug is way less fussy.

[Scarebird]

Originally Posted by Verdoro 68

It looks easier to plug in than it is. The sockets have a tendency to slip out of the connector and you have to have it clocked just right. The flat GM plug is way less fussy.

This is also the design and plug for a 1966-67 Cutlass/442 - may even be the same exact moulding.

They do NOT take multiple fittings well and will pull the prongs off the circuit "board".

I can verify it is horrible.

[Cerberus]

Been feeling your pain with the lack of aftermarket parts and scarcity of used/original. Went to the AMO show last month in South Bend. Met a bunch of nice people that were willing to share their knowledge and a few that gave me killer deals on parts. Started with a budget of $800. Three short hours later, I'd spent close to $2500.

I purchased an Eaton power steering pump and brackets, to remain "correct". Been reading the issues with leakage in the Eaton and being I have a 74 or 75 401, which uses Saginaw, I went that direction.

Taking my time and being careful on the restart. It seems the engine was rebuilt but was not ran, or ran very little as there is still assembly lube on the valvetrain. Scoped the cylinders - 060 over pistons and clean cylinders/pistons with no pitting.
Need to update my thread.

[will slow gto]

Always love seeing updates to your thread. That trans was a lucky score but you’ve earned your luck with this one. Before you know it, this car is going to end up with two good looking sides :-)