| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
06-18-2006, 11:05 AM
|
|||
|
|||
Cam gear alignment help needed
well, in Jim Hands book i've noticed he aligned the crank and cam gears dots both in the 12oclock position. i believe i have aligned the dots with the cam gear dot on the 6oclock and the crank gear at the 12oclock positions. now this seems simple enough, but i am a little confused. any guidance will be appreciated. thanks.
|
|
#2
06-18-2006, 11:17 AM
|
||||
|
||||
|
the crank spins twice for every single revolution of the cam, so you are fine, spin the crank around one revolution, and you'll have both dots at 12:00.
__________________
1968 Lemans/GTO clone, 6-71 blown 474ci 1969 Ram air III, Hardtop (sold it to my dad!! still care taking for it) |
|
#3
06-18-2006, 12:50 PM
|
||||
|
||||
|
12 and 12 is the actual TDC for #1 cylinder--necessary when rough-aligning your distributor to point to #1 for initial setup of the distributor. 6 and 12 just makes it easier to align the gears and chain during installation.
|
|
#4
06-18-2006, 06:30 PM
|
|||
|
|||
|
thanks guys, i got worried for nothing. if i would have just slowed down a bit i would have realized i was okay. i just panic sometimes after i've got an engine together. again, thanks.
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
