| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
|
|||
|
|||
|
Any out there that is compatible with the 71-72 venturas?
|
|
#2
|
||||
|
||||
|
I run an al. griffin. I have no idea if it wider than stock, but it is thick. There is a sticker on it, I'll see if the p/n is on that.
|
|
#3
|
||||
|
||||
|
Are they the same as a 73-74? I run an aluminum off ebay, works well so far.
__________________
Derek B. Current best: 11.97@110 1.65-60' !!! '74 ventura, (Fired july 14/06) '74 462 4-bolt (9.5-1), SCAT, Ross, T-II w/850DP (shaker455), TH350, Conti 10'' 3800, Supercomps, Magnaflow, 3'' Pypes, 3.73's, 28x13.5-15 ET streets.1970 Beismeyer 17' flatbottom vdrive, 11.8:1 455P, ported heads, dual Qjet tunnel ram.
|
|
#4
|
||||
|
||||
|
no p/n just phone # for Griffin.
|
|
#5
|
||||
|
||||
|
Besides 2 different stock radiators, I've had two different aluminum radiators in my car.
The current set up is using a 22x19" GM style universal with a single 1560 cfm S blade fan pushing and Mezeire water pump. I haven't noticed temps any higher then 170 after back to back passes and a little street driving, I have the grill plugged as well. ![]() ![]() I did have to make my own mounting brackets for this radiator. Before I had a 31"x19 universal with the same fan pulling but had a stock replacement water pump and the grills open. Temps stay around 160 constantly after I figured out the thermostat opening size. I had 3 thermostats stick so now I just run a restricter. Mounting was easier as I could use the stock mounting configuration. ![]() I believe the stock radiator dimension is 26x19. HTH |
|
#6
|
||||
|
||||
|
I measured my radiator. Is is 3" thick and 30 1/2" wide.
|
|
#7
|
|||
|
|||
|
i am thinking about putting a 3 row in my 6 cyl. is that overkill?
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|