 |
|
| Members Helping Members help Buying a non Pontiac item, transportation help, Handy-man advice, directions, vacation ideas, places to dine, ebay and generally anything you think might help other members. |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
|
#1
10-13-2014, 08:19 PM
|
||||
|
||||
2007 Denali front airbag sensor code.
Got an airbag code today. Scanner says the code is B0084. Front impact senor #2.
85 bucks a piece... So, can I use a used sensor. Is there any reprogramming that needs to be done? and which one is sensor #2 |
|
#2
10-13-2014, 10:36 PM
|
||||
|
||||
|
So I'm reading on line that this code may also be caused by broken wires under the front seats. Cleaned the truck the other day and ran both front seats all the way to the rear then all the way to the front to vacuum.
I guess tomorrow I check the wires under the seats and clean the connectors on the impact sensors and see if the code resets.. |
|
#3
10-15-2014, 09:34 PM
|
||||
|
||||
|
Right Front impact sensor (#2, pass side), purchased at OReilly's for $85 bucks. Remove key from ignition. Pull the airbag fuse, raise the front end a little to make it easier. 10 mm wrench to take it off the core support, a screwdriver to pop the clip & the plug out. Install the new unit & replace the 15 amp airbag fuse. Start the truck and the code should be clear..
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
