FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
|
The Body Shop TECH General questions that don't fit in any other forum |
Reply |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Dose any make the lower rear qtr patch panel? I see them up through 69.
My drivers side, right behind the wheel is gone for about 6 inches. Rest is ok. Am I om my own here? How close would the front edge of a 69 be to what I need? Thanks, Randy |
#2
|
|||
|
|||
Not that I've seen, and the '69's are not even close.
Your best bet may be to use a partial quarter panel, and use only what you need. Yes, it will cost about $100, and you'll probably only use about 25% of it, but that's the best ready-made alternative. Otherwise, fabricate the patch panel yourself, to the exact dimensions you need. I've done this in the past, and it's not that difficult, if you have any basic metalworking skills whatsoever. |
#3
|
||||
|
||||
TJH,
Thanks for the info. I was afarid there wasn't anything out there. Looks like I will make it up myself. Randy |
Reply |
|
|