| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
|
|||
|
|||
|
Is it really necessary to put two sending units for water temp in a 72 Lemans with rally gauges? I got a hand writen wiring diagram that states that I need two sending units for water temp. Is this right?
|
|
#2
|
|||
|
|||
|
Is it really necessary to put two sending units for water temp in a 72 Lemans with rally gauges? I got a hand writen wiring diagram that states that I need two sending units for water temp. Is this right?
|
|
#3
|
||||
|
||||
|
One of the senders is for the gauge, the other is for the TCS system. I'll need to check out my old info but I believe it was there to advance the ignition timing when the coolant reached a certain temperature (near overheat) to help cool the engine down.
Hope this helps, Lloyd
__________________
Regards, "455HO" Lloyd 2008 GMC Sierra Denali 2WD Crew, L92 6L80E, Silver w/ Ebony guts, 14.26 @ 98 |
|
#4
|
|||
|
|||
|
It isn't a stock Lemans It now has a non-vacuum advance dist. I now have a MSD Ignition. By not putting this sender in would it effect the gauges function? I just wanted to put the rally gauges in my car. Pretty much everything on the engine in aftermarket (intake, carb, ignition system exhaust etc). The only vaccum line I have is for the trans modulator!
|
|
#5
|
||||
|
||||
|
You don't need the additional sending unit - just install the one sender for the gauge.
Later, Lloyd
__________________
Regards, "455HO" Lloyd 2008 GMC Sierra Denali 2WD Crew, L92 6L80E, Silver w/ Ebony guts, 14.26 @ 98 |
|
#6
|
|||
|
|||
|
Cool! Thanks alot
|
| Reply |
|
|