| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
04-28-2003, 08:52 PM
|
||||
|
||||
What is the minimal allowable clearance between the inside of the rear quarter and the rear tire? I want to put a set of mags on my 66 wagon. Original rims left 1.5 inches between rubber and steel, mags leave only 0.5 inch. Dare I try or am I going to screw up my quarters?
|
|
#2
04-28-2003, 08:52 PM
|
||||
|
||||
|
What is the minimal allowable clearance between the inside of the rear quarter and the rear tire? I want to put a set of mags on my 66 wagon. Original rims left 1.5 inches between rubber and steel, mags leave only 0.5 inch. Dare I try or am I going to screw up my quarters?
|
|
#3
05-10-2003, 01:33 PM
|
|||
|
|||
|
Keith, I just went and measured my 64 Lemans with P275-60-R15 on Crager mags, I have 3/4 inch between the outside of the tire and the inside lip of the fender. I've never touched.1/2 inch is a little close but if you own the mags you could give it a try. If you dont have them I wouldn't buy them. Merlin
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
