| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#16
03-26-2005, 10:50 PM
|
||||
|
||||
this a 455, it had been decked and has edelbrock heads on it. this is a performer intake.
when we went to put the intake manifold on it would not bolt up. the bolt holes were off by a very small amount. is it okay just to use a dremel to enlarge the holes or does teh intake have to be machined down
__________________
70 GTO 462 E-Heads TKO-600 9-Inch/3.60's |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode