| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
07-31-2006, 11:41 PM
|
|||
|
|||
need pushrod help
72 455 with 65, 389 heads didn't build this engine ran good for years has very short pushrods for pontiac with tape measured 8 11/16 was going to adjust valves found two worked over, metal covers oil hole on rocker end one more was bent all pushrods I have looked at are over 9 inches should I buy some same as these because car screamed or possibly buy longer pushrods hard to determine no engine specs on cam or stroke ????????? HELP HELP HELP!!!!!
 
|
|
#2
08-01-2006, 01:11 AM
|
||||
|
||||
Welcome to the PY forums!
Hint- don't post the same question in multiple forums here. See my response to your post in the 'Street' forum. |
|
#3
08-01-2006, 07:24 PM
|
|||
|
|||
|
thanks for the help going to check things out sorry I doubled up I'm new here I figured more exposure was better I'll hold it to one thanks again
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
