 |
|
| Pontiac - Street No question too basic here! |
| View Poll Results: Which engine with stock heads? | |||
| '69 400 with 62's |
   
|
15 | 32.61% |
| '74 455 with 4x's |
  
|
31 | 67.39% |
| Voters: 46. You may not vote on this poll | |||
|
|
Thread Tools | Display Modes |
|
#2
11-11-2006, 02:41 PM
|
||||
|
||||
The 400 w/62's will be too much compression for pump gas without the right cam to bleed off some cyl. pressure (my 400 w/670's was the same way but i ran a RAIV cam which bleed off cyl. pressures.). Even with the right cam you will need some decent gears and conv. (if auto) to have this thing perform. I would personally put in the 455, even with low comp. it will have torque (more torque = more fun). It will be nice to run with 87 gas too.
__________________
Derek B. Current best: 11.97@110 1.65-60' !!! '74 ventura,  (Fired july 14/06) '74 462 4-bolt (9.5-1), SCAT, Ross, T-II w/850DP (shaker455), TH350, Conti 10'' 3800, Supercomps, Magnaflow, 3'' Pypes, 3.73's, 28x13.5-15 ET streets.1970 Beismeyer 17' flatbottom vdrive, 11.8:1 455P, ported heads, dual Qjet tunnel ram. 
|
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode