Pontiac - Street No question too basic here!

          
Reply
 
Thread Tools Display Modes
  #1  
Old 01-18-2008, 03:14 AM
topdown's Avatar
topdown topdown is offline
Senior Member
 
Join Date: Aug 2005
Posts: 140
Default Replacing OHC6 with V8. Swap question.

I'm replacing the OHC6 in my '69 LeMans 4-speed with a 462. I've got the mighty mounts for the 400 block ('68), will the mount brackets on the frame be the same and bolt right up, or do I need V8 specific brackets? Anything else I need for the swap? I got the bellhousing already, is the clutch linkage all the same? Thanks! With any luck it'll go in next week. (Can't wait!)

  #2  
Old 01-18-2008, 07:50 PM
Half-Inch Stud's Avatar
Half-Inch Stud Half-Inch Stud is offline
Ultimate Warrior
 
Join Date: Jul 2000
Location: BlueBell, PA or AL U.S.A.
Posts: 18,895
Default

Firebird needed the V8 Specific receiver mounts. I dunno about the LeMans

  #3  
Old 01-18-2008, 08:02 PM
boater bill's Avatar
boater bill boater bill is offline
Chief Ponti-yacker
 
Join Date: Apr 2007
Location: Cape Coral Florida
Posts: 917
Default

Quote:
Firebird needed the V8 Specific receiver mounts. I dunno about the LeMans
The Firebird with OHC-6 was offset about 1/2 inch to the passenger side. I would think the Tempest would also.

Clutch linkage is the same, the ball stud for the block is different between V8 and OHC-6.

Hope this helps

  #4  
Old 01-18-2008, 08:12 PM
engineer engineer is offline
Suspended
 
Join Date: Aug 2002
Location: usa
Posts: 6,016
Default

frame mounts are different between an OHC6 and a V8


Last edited by engineer; 01-18-2008 at 09:01 PM.
  #5  
Old 01-18-2008, 08:17 PM
Matt Meaney's Avatar
Matt Meaney Matt Meaney is offline
Ultimate Warrior
 
Join Date: Aug 2006
Location: torrington ct
Posts: 1,435
Default

the frame mounts on the ohc6 are different. looked into that when i had my 68 lemans. went out and found a set of V8 mounts, but sold the car before i made the swap. i'll look for them tomarrow and snap a couple pics. maybe a visual and/or some measurements will help. it's been a few years, but i'm thinking the ohc's were taller.

  #6  
Old 01-18-2008, 08:31 PM
chipster's Avatar
chipster chipster is offline
Chief Ponti-yacker
 
Join Date: Jun 2003
Location: Eaton, Ohio
Posts: 608
Default

The six-cylinder mounts are wider. Also, the starter and fuel pump will be on the left side with the V-8, you will need to move the battery, cables, and fuel lines. The six cylinder throttle cable will probably also be too long. You will need V-8 coil springs on the front if you don't want to be scraping the ground. You will probably need a bigger radiator too.

  #7  
Old 01-18-2008, 09:02 PM
engineer engineer is offline
Suspended
 
Join Date: Aug 2002
Location: usa
Posts: 6,016
Default

might be interested in a mount swap, Pm me if interested.

  #8  
Old 01-20-2008, 01:22 AM
SPEEDSTAR! SPEEDSTAR! is offline
Junior Member
 
Join Date: Oct 2007
Posts: 1
Default

My 4BBL OHC6 gets 18 mpg. It's in my '67 Firebird. I rebuilt it ten years ago. The 462 cu in. engine in my '77 LeMans Sport Coupe gets 8 mpg. Guess which one gets driven most? Wasn't always that way, but at $3.50 a gallon, the gas pains are getting unbearable. Just spent $70 bucks tonight to put 20 gallons into the LeMans. You can't, however, beat the almost 500 horses the V8 puts out!!

Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:41 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017