FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
|||
|
|||
Pypes X-Pipe with Cutouts:
I need a center-to-center measurement of the pipes on the 2.50" Pypes X-Pipe with cutouts, to see if it will readily adapt to a running vehicle I have been asked to work on.
Thanks...Robert |
#2
|
||||
|
||||
at the rear or the front? What car?
__________________
--------------------------- Fool Around, Get Hurt, Don't come Crying to me. |
#3
|
|||
|
|||
Sorry....Second Generation Firebird.....width where headers attach...Robert
|
#4
|
||||
|
||||
My Pypes kit was adjustable in the front for width. I just have the standard X pipe, but I would think that the X-change would be roughly the same concept for fitting.
Dave |
#5
|
|||
|
|||
Thanks for the information...
I need to install one of these for a customer where an existing system is already in place. We hope to keep as much of the nearly new system (already on the car) as possible....Robert |
#6
|
||||
|
||||
The rear legs of XVX10S will run under the floor boards at about 18" apart and limit ground clearance. Pypes has a new product XVX10F which replace the front legs of the XVF10 F-body X pipe. These front legs have dumps on them. With this configuration, you won't loose any ground clearance. The front legs can be adjusted from 24" down to 20". The rear legs are about 12" apart.
__________________
--------------------------- Fool Around, Get Hurt, Don't come Crying to me. |
Reply |
|
|