| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
01-09-2009, 12:13 PM
|
|||
|
|||
Oversize Thrust Bearing
4-bolt, 455' block with non-matching factory caps. Line honing will cure the bore, but thrust surface misalignment is the problem. Jim Hands book(page 26) mentions overthick thrust bearings. Has anyone used these? Is this the solution? Are they still available? Where? Other expert suggestions or comments...Thanks.
|
|
#2
01-09-2009, 12:20 PM
|
||||
|
||||
|
Over thick thrust bearing are ONLY available for a .040 under crank. As far as I know. Thats what we carry.
Ace
__________________
Am I glad I got out of the business I was in? HELL YEAH!!! |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
