| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
 |
|
Menu
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
01-20-2009, 09:49 AM
|
|||
|
|||
Aluminum Restoration
Not sure this is the right place to put this but at least many will see it. I have some cast aluminum parts that are scratched from years of service. Screw driver scratches and the such......Nothing greatly deep. I'd rather not paint the parts. What are the proper steps to restore these pieces? Should I be looking at bead blasting? I do not want to remove any detail or part numbers. Thanks in advance.
|
|
#2
01-20-2009, 10:06 AM
|
|||
|
|||
|
I'd look at blasting them to remove scratches.
Final finishing will depend on what the parts are. Mike
__________________
so many pontiacs, so little time.................. moderator is a glorified word for an unappreciated prick.................. "Only two things are infinite, the universe and human stupidity, and I'm not sure about the former." --Albert Einstein "There is no such thing as a good tax." "We contend that for a nation to tax itself into prosperity is like a man standing in a bucket and trying to lift himself up by the handle." - Winston Churchill |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
