| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
02-20-2010, 09:19 AM
|
||||
|
||||
Printed Circuit help
I've been asked by a friend to help him replace the printed circuit on the back of his instrument panel on a 69 GTO. Are there any tricks? I've done it on Birds but not an A body. It has A/C so that will add to the fun. How much time should we figure on to do the job?
|
|
#2
02-20-2010, 02:59 PM
|
||||
|
||||
|
pull the dash
You need to pull the dash, which takes about an hour. half hour to replace the printed circuit. Probably another hour to two to replace the dash.
While you have everything out, you might want to at least clean the gauges, maybe put in a new lens if it needs it. Here's some articles on the process: http://forums.maxperformanceinc.com/...t=dash+removal
__________________
1969 Judge, 4-speed, CR/Parchment, Quasi-Survivor, #'s match - under restoration 76 Cutlass Salon, 54,000 original miles. Last edited by getmygoat; 02-20-2010 at 03:06 PM. |
|
#3
02-20-2010, 07:25 PM
|
||||
|
||||
|
Thanks for the info. I'll check out the link
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
