| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
|
||||
|
||||
|
Just purchased 4 honeycombs and they need to be redone to be show quality. Wondering if anyone has tried powder coating or would the heat damage the polycast? Appreciate any thoughts.
Thanks. |
|
#2
|
||||
|
||||
|
I wouldn't try it. Powder coating requires temperatures in excess of 400 degrees, sometimes as high as 700 - I don't think the polly would make it, and if it did I would be concerned that it was still attached to the steel.
Do a search in the 70-72 A body or the 70-73 F body tech sections - there are plenty of threads on how to restore these wheels.
__________________
Some guys they just give up living And start dying little by little, piece by piece, Some guys come home from work and wash up, And go racin' in the street. Bruce Springsteen - Racing In The Street - 1978 |
|
#3
|
||||
|
||||
|
Business that does the powder coating in my area stated 400 deg temp which is pretty toasty. I was wondering if anyone had done it with success, I guess paint might be the way to go! Thanks Boss
|
|
#4
|
|||
|
|||
|
another thing to consider is that powder coating requires an electrical charge that attracts the powder to the part.... honeycombs are basically rubber on the inserts. i bet the powder wouldn't stickvery well if at all.
|
|
#5
|
|||
|
|||
|
You can sandblast them and then paint them. The blasting will get all the old paint off but bounce off the polycast/urethane. I did it. Use appropriate paint for the urethane.
|
|
#6
|
||||
|
||||
|
You can buy the correct Honeycomb paint in spray cans...it has a grainy, "cast" like surface to it that isn't like most normal auto paint.
__________________
Regards, Leigh Pontiacs I’ve owned…. 1960 Laurentian 283 1963 Laurentian 283 1976 Trans Am 400 1977 Trans Am 400 1951 Chieftain Flat head 6 1967 Firebird 400 convertible 1967 Firebird 400 coupe 1979 Trans Am 403 1971 Formula 455 (clone) 1969 Firebird 350 1968 Firebird 428 manual. Sydney, Australia |
| Reply |
|
|