[1972jim]

Just the pedals/dash hardware to convert auto to stick.

[Doug]

I lost track of this post and had to ask in 61-63 Tempest & Lemans forum where to find it. c5farmer told me where to find it again.

When I first read your post I had forgotten that I had some of this stuff. I stumbled on it under a bench today. I have the pedals and the "hoop" bracket that ties them together.

I don't have the under-dash piece that the pedals mount to. The only difference between that piece itself in an automatic car and a manual car is that the manual one has a small piece of angle iron mounted on the side of it. That angle piece has a small flat piece of rubber on it. The purpose of that "angle" is it serves as a "rebound stop" for the clutch pedal when it is released. You can use your auto under-dash piece and bolt a small piece of angle iron on it and it will serve exactly the same as a manual setup does.

Do you have ANY of the clutch pedal setup? Under hood pieces? Bolt-to-motor bolt?

[1972jim]

I don't have any pieces under the hood or engine bolt. I'm going to run a hydraulic clutch set up.

[JohnFromVentura]

You might use one that the master cylinder mounts under the dash ... there is almost no room to mount it on the firewall! John

[Doug]

Here is a pic of the pieces I have. You can have them (less the pads which I need for my car) for $10+shipping.

[1972jim]

Send me your address and the total and ill send you out a check. Thanks! Jim

[Doug]

Originally Posted by 1972jim

Send me your address and the total and ill send you out a check. Thanks! Jim

Pedals sold to another member a few days ago.