| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
12-05-2016, 07:27 PM
|
||||
|
||||
motor mounts
i got a 1980 transam am trying to switch from factory rubber mounts to the butler solid mounts mounts and motor not lining up any recommendations would truly be appreciated thanks
|
|
#2
12-05-2016, 09:52 PM
|
||||
|
||||
|
I know what you mean. I had the same problem. You have to just keep messing with them. I got a bolt started in one side and then with a screw driver I wiggled it around in the other mount until I got it to the point where I was able to get the other bolt started. Do you have the bolts that are pointed on the end? If you don't , that's part of the problem . The point helps locate it in... Once you get the point in there , you can tap it lightly with a mallet until its close enough to get the thread engaged and started ..
__________________
My Half AN Injun..... |
|
#3
12-06-2016, 07:37 AM
|
||||
|
||||
|
Leave the mount to block bolts good and loose until you get the long bolt started !
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
