| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
05-27-2017, 11:51 AM
|
||||
|
||||
1964 Tempest Custom Front Fender Trim
The 3 pcs on front fender.
Thanks Tony |
|
#2
05-27-2017, 05:28 PM
|
|||
|
|||
|
trim
tony
will it matter?? left or right side.... i may have it |
|
#3
05-27-2017, 07:28 PM
|
||||
|
||||
|
TOYSWEDO, PM sent
|
|
#4
05-30-2017, 06:19 PM
|
||||
|
||||
|
Still looking...
|
|
#5
05-31-2017, 08:38 PM
|
||||
|
||||
|
Check out Ebay there's some on there now. You do know all three pieces are different, (part#s) three left top middle bottom -three right top middle bottom.
|
|
#6
06-05-2017, 07:01 AM
|
||||
|
||||
|
tiacguy, no, I didn't know that. I was at the body shop Saturday and I was shown that the back of the part had the part number. There was a LH9774160 and a RH9774159. When I got home, all my trim pieces were one of the (2) numbers I just listed. I'm thinkin' that the parts are either right hand or left hand. Are you sure there are 6 part numbers? Oh, and I did see a set on e-bay. They were very pitted from what I could see. I'm going to look again now, to make sure it's not a different set. Thanks for the help.
Tony |
|
#7
06-14-2017, 07:34 PM
|
||||
|
||||
|
Still looking. Specifically need the (3) pieces of part number RH 9774159.
Thanks |
|
#8
06-15-2017, 01:15 PM
|
||||
|
||||
|
Sorry Tony I didn't see your post. I'll get the part numbers for you so you know what your looking for. I have the same car and went through the same thing you are . I have all the originals from my Tempest Custom. If you look at the molding piece you'll see that it's actually tapered the way it sits on the fender the top sits closer to the fender than the bottom. There is a center pin in each piece that locates them on the fenders. You can't put them in the wrong place. There are three left and three right. I'll post later today when I get out to the garage for the part numbers. Scott
|
|
#9
06-15-2017, 06:35 PM
|
||||
|
||||
|
Tony I looked at these ornaments and I was wrong. You are correct there is only two part numbers 9774160 left side and 9774159 right side. What I got messed up is the fender has a center location pin for each emblem. I remembered this wrong Sorry for confusing you. There is an NOS right side on EBay now for $59.00. Scott
|
|
#10
06-15-2017, 08:23 PM
|
||||
|
||||
|
Thanks Scott. Going to look right now.
I just checked ebay under "1964 tempest fender trim" and danged if I couldn't find it. Was it listed differently? Last edited by tempest1964; 06-15-2017 at 08:29 PM. |
|
#11
06-16-2017, 05:58 AM
|
||||
|
||||
|
see if this works
http://www.ebay.com/itm/NOS-1964-196...FSC8eZ&vxp=mtr I always type in Tempest Custom they weren't used on the Tempest. |
|
#12
06-16-2017, 01:00 PM
|
||||
|
||||
|
The standard Tempest used those exact same trim pieces on the lower front fenders, they're not exclusive to the Tempest Custom.
__________________
1964 Tempest Coupe LS3/4L70E/3.42 1964 Le Mans Convertible 421 HO/TH350/2.56 2002 WS6 Convertible LS1/4L60E/3.23 |
|
#13
06-16-2017, 03:25 PM
|
|||
|
|||
|
Found 3 - 59's and 1 - 60 NOS. Not sure I have access to them at this time.
__________________
Practicing social distancing for 65+ years |
|
#14
06-19-2017, 06:31 PM
|
||||
|
||||
|
Thanks for the input guys. I scooped up the NOS piece. The other 3 I saw were rougher than mine. Still looking for 2 nice quality pieces if possible, before re-assembly
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
