| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
09-25-2019, 09:33 PM
|
|||
|
|||
Brake line routing with factory RA exhaust manifolds in a '65?
I recently installed factory RA cast iron headers since the previous set of aftermarket headers gave up the ghost. I am concerned with how close the brake line is going along the frame and cross member to the passenger side disk. This is in a '65 chassis. Anyone have pics of an alternate routing? I don't want to put it in front of the cross member due to potential road trash getting kicked up and damaging the brake line.
__________________
Inside of every small problem there is a big one struggling to get out..... |
|
#2
09-26-2019, 06:12 AM
|
||||
|
||||
|
Putting the lines on the front of the crossmember is the way the factory did it in 67. The lines then went under the sides of the frame and wrap around the outside after the control arms. Spring wrap will offer protection.
Sent from my iPhone using Tapatalk
__________________
NOT a GTO. 1965 LeMans 455 |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
