01-26-2021, 10:35 AM

shermanator2 shermanator2 is offline

Senior Member

Join Date: Nov 2010

Location: San Diego, CA and Niwot, CO

Posts: 120

Quote:

Originally Posted by 242177P

If the 2184 is THE lifter to use, would it make sense to source round .875 ID shims?
Like the dogbones, they'd still need to be fitted to the block, but that's a lot easier
than milling a step into the bottom of a dogbone.

Unless these were epoxied to the block I don't think this works. If they are floating, the "corners" of the lifters will catch these and lift the shim washer and the dog bone up.

Reply With Quote

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 06:49 AM.

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

Menu

About Us