[Vettdr]

Okay, so my car is home from the paint shop. I'm in the process of re-assembly. Hot wired the car to get it running. Now i'm wiring the car, and can't for the life of me find a pic of the correct route for the trunk harness. I didn't take it apart so I'm not familiar where the harness goes. Can someone send a pic or tell me the correct route? Thanks in advance.

[boltbuster]

Use the following link. It will get you to the information that I think you need. Good luck with your project: http://forums.maxperformanceinc.com/...25#post6170125

[Vettdr]

Thanks boltbuster but that's not my issue. I'm refering to the whole trunk harness that goes to the tail/brake lights. Does it lay above the light housings, or does it lay under the housings? Does it run thru any of the rear panel openings, or does it just lay without clips? Any ideas?

[boltbuster]

Originally Posted by Vettdr

Thanks boltbuster but that's not my issue. I'm refering to the whole trunk harness that goes to the tail/brake lights. Does it lay above the light housings, or does it lay under the housings? Does it run thru any of the rear panel openings, or does it just lay without clips? Any ideas?

The quick answers are as follow: the harness runs above the light housings; the factory harness had nylon pins wrapped on to it that pushed into small holes in the back panel to secure the wire.

I'll try to take some pictures for you if you need them.

[gto4ben]

I hope these photos can help.

[Jeff Hamlin]

...

[Jeff Hamlin]

Hope these help...

[Vettdr]

Perfect! Thanks guys. That's exactly what i was looking for.