| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
07-16-2023, 09:31 PM
|
||||
|
||||
Vacuum modulator line routing
Nitpicky question - I'm wondering if I've got the steel line and the vacuum switch hoses routed correctly at the intake. I tried putting the trans line under the hoses, but the loop in the steel line sits just a little too high. I've got the bracket on the bellhousing to hold the trans line and it fits well everywhere else. It just looks like things should fit together better at the intake. The bends in the steel line must be there for a reason.
__________________
Ken '68 GTO - 464 - Ram Air II heads - 236/242 roller - 9.5” TSP converter - Moser 3.55 Truetrac (build thread | walk around) '74 Ventura 350 '69 AMC Javelin SST |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
