 |
|
| Members Helping Members help Buying a non Pontiac item, transportation help, Handy-man advice, directions, vacation ideas, places to dine, ebay and generally anything you think might help other members. |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
03-02-2026, 03:54 AM
|
||||
|
||||
Junk carb parts needed
I've got this crazy side project of building an electronic servo controlled choke for 702/704 carbs. I'm not a carb guy, so I don't have parts lying around. I need a Quadrajet center section with the choke parts attached. It can be total junk but with a good choke plate, rod, and that mess of stuff that goes between the choke stove and choke plate
 Only Qjet I have is installed on my GTO and I need to make many, many accurate measurements which would be a nightmare to do on the car. BTW, the OEM choke on the 704 I have installed on my 68 works fine so far, this project is just a lark, just to practice my Arduino programming and 3d printing. Plan is to be able to control the choke position based on the temp at a temp sensor placed any place on the engine you want, or to be able to dial up a choke position using an over-ride knob inside the car. Thanks
__________________
I'm World's Best Hyperbolist !! |
|
#2
03-02-2026, 10:48 AM
|
|||
|
|||
|
PM sent.
|
| The Following User Says Thank You to Mr. G For This Useful Post: | ||
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
