| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
06-29-2026, 12:12 AM
|
|||
|
|||
66 GTO clutch spring location
Is this the correct spot on the body for the heavier clutch return spring. It don’t seem like a straight pull.
|
|
#2
06-29-2026, 12:28 AM
|
|||
|
|||
|
Clutch return spring
For some reason my pic won’t post but the hole I’m referring to is just in front of body mount below the cowl. Not a straight pull and about 8” from z bar.
|
|
#3
06-29-2026, 12:41 AM
|
|||
|
|||
|
For some reason my pic won't load.
|
|
#4
06-29-2026, 12:57 AM
|
|||
|
|||
|
spring
the last time I will try to post pic
|
|
#5
06-29-2026, 09:31 AM
|
||||
|
||||
|
This is the best pic I could find when researching for my 66:
__________________
Fort Worth/Dallas TX area 1966 GTO Fontaine Blue 389 CID Carter AFB Muncie 4 speed (orginally an automatic car) |
|
#6
06-29-2026, 10:14 AM
|
|||
|
|||
|
Return spring
I think I’m good. Now if I could get the measurement of where the hole goes on the Z bar. Either measure from tip to hole or up from the tube. Is the hole on flange of bar or the flat surface? My bar must be aftermarket. No hole.
|
|
#7
06-29-2026, 05:15 PM
|
||||
|
||||
|
The hole is located 4" down from the center line of the push rod see pic looking down from my fender well. Second attachment is a snip from an electronic copy of the 66 Tempest Shop manual just for your info.
__________________
Fort Worth/Dallas TX area 1966 GTO Fontaine Blue 389 CID Carter AFB Muncie 4 speed (orginally an automatic car) |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
