 |
|
| Performance Parts For Sale/Wanted Just Performance, non-stock, trailers, tools and related accessories here. |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
06-29-2026, 12:43 PM
|
|||
|
|||
1958 Original Pontiac T395A Factory Racing Exhaust Manifolds 530962 & 530965 FOR SALE
I have a Pair of highly sought-after, legitimate matching pair of 1958 Pontiac T395A high-performance / racing cast-iron headers/manifolds FOR SALE
Located in Yuma, AZ and Willing to Ship Asking $3000 Manifolds have been checked and high temp powered coated a silver color previously. There was a small pin hole on the Driver side back (towards engine block that was professionally brazed and repaired Passenger side heat riser has been removed and blocked off Flanges have been machined flat Passenger Side (Casting #530962): This is the correct, physical casting number for the right-hand side. While the official GM Master Parts Catalog listed the inventory part number as 530961, the actual hot-metal cast mold was stamped 530962.Driver Side (Casting #530965): This is the exact matching left-hand side physical casting number for the 1958 T395A application Original 1958 Pontiac T395A racing/high-performance exhaust manifolds (commonly paired with 3-2bbl setups or Fuel Injection) are extremely rare, with only about 300 sets reportedly produced. I have lots of Photos upon request |
| The Following User Says Thank You to The Motor Pool For This Useful Post: | ||
|
#2
06-30-2026, 02:39 PM
|
|||
|
|||
|
Super cool
__________________
"At no time did we exceed 175 mph.” Dan Gurney's truthful response to his and Brock Yate's winning of the first ever Cannonball Baker Sea-to-Shining Sea... Still have my 1st Firebird 7th Firebird 57 Starchief |
|
#3
06-30-2026, 06:40 PM
|
||||
|
||||
|
Look like beauties. Good luck!
__________________
1964 Tempest Custom 421 SD clone KRE 74cc heads KRE 230°/236° hydraulic roller cam Rebuilt 3.23 rear end |
|
#4
06-30-2026, 11:57 PM
|
||||
|
||||
|
They sure are rare!
But I went more for performance of the '58 in my GMC. I un-siamesed the center exhaust ports to effectively use long-branch manifolds.
__________________
Anybody else on this planet campaign a M/T hemi Pontiac for eleven seasons? ... or has built a record breaking DOHC hemi four cylinder Pontiac? ... or has driven a couple laps of Nuerburgring with Tri-Power Pontiac power?(back in 1967) ... or has a Pontiac born the same year as Jim Wangers? (1926} 
Last edited by Jack Gifford; 07-01-2026 at 12:03 AM. |
|
#5
07-02-2026, 07:18 PM
|
|||
|
|||
|
I am open to offers
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
