| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
 |
|
Menu
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
03-28-2021, 12:33 AM
|
|||
|
|||
1968 endura bumper fender paint chipped
I just got my car back from having it painted I made my 1st trip out to a car cruise and noticed a paint chip on driver side where endura bumper mounts up to fender. A guy told me that the bumper moved or rubbed. I hit. A small pot hole not hard is this what would of caused this to happen. Thanks. MJM1968
|
|
#2
03-29-2021, 11:56 AM
|
||||
|
||||
|
There should be a space between the the bumper and the fender, mine is set at 1/8 of an inch. That gives you some room for them to move independently of each other. If there tight it will definitely cause a chip.
__________________
1969 GTO street strip project 11.1 forged 461, highport heads 1995 Trans-am 420 ci sb 14:1 compression 9"ford 9.89@132 1.34 60ft SOLD! |
|
#3
03-29-2021, 12:07 PM
|
||||
|
||||
|
It can definitely happen. As stated, there should be a little bit of space between the endura and the fenders. Hard for that paint to hang on right at that sharp rear edge if the fender is banging on it.
__________________
Greg Reid Palmetto, Georgia |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
