#1  
Old 07-30-2020, 01:40 PM
supersport#69 supersport#69 is offline
Chief Ponti-yacker
 
Join Date: Oct 2018
Posts: 523
Default 68 gto 4 speed Muncie question

What should the diameter of the clutch plate and pressure plate be from factory?

I ordered a replacement from Napa and it’s not fitting according to what the book measurements show. By the size of the one that came out the only one they have that matches calls for a vette. Will that work if it’s the same size?

  #2  
Old 07-30-2020, 02:47 PM
geeteeohguy's Avatar
geeteeohguy geeteeohguy is offline
Ultimate Warrior
 
Join Date: Dec 2009
Location: Fresno, California
Posts: 5,313
Default

10.4" is the stock diameter. The same disc was used in all GM cars except for the big block Chevs and 455 later Pontiacs, which used an 11" disc.

__________________
Jeff
  #3  
Old 07-30-2020, 03:08 PM
supersport#69 supersport#69 is offline
Chief Ponti-yacker
 
Join Date: Oct 2018
Posts: 523
Default

Thank you. I guess the vette 10 1/2 should be good..

  #4  
Old 07-30-2020, 03:35 PM
Old Man Taylor's Avatar
Old Man Taylor Old Man Taylor is offline
Ultimate Warrior
 
Join Date: Dec 1999
Location: Escondido, CA, USA
Posts: 6,945
Default

The good Vette clutch was 10 3/8" (10.375). Just like the Pontiac. The best one was the L88, which is no longer available. I have a few NOS coarse spline L88 discs, but I don't have any pressure plates.

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:17 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017