| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
09-20-2002, 11:32 AM
|
|||
|
|||
where can I purchase a new crush sleeve for a 8.2 ring and pinion or can I reuse the old one?
Thanks Darren 1969 Judge 71 455HO holley projection M22 rock crusher 3.90 gears |
|
#2
09-20-2002, 11:32 AM
|
|||
|
|||
|
where can I purchase a new crush sleeve for a 8.2 ring and pinion or can I reuse the old one?
Thanks Darren 1969 Judge 71 455HO holley projection M22 rock crusher 3.90 gears |
|
#3
09-20-2002, 11:51 AM
|
|||
|
|||
|
Darren, ck you local GM dealer for crush sleeve for a 7.5" or 7.625" ('78+) 10 bolt rearend. GM parts nomeclature will call them a spacer. These are what are being put in the Federal Mogul bearing kits & they work perfect.
Reusing crushsleeves...if you had 30 used crush sleeves out of 30 different rearends might have one that was thick enough to crush a little more, when pinion nut is tightened to set drag. I used to mike these & keep only the thickest. Anymore chunk all the used ones, as very few were ever thick enough.
__________________
Buzzards gotta eat... same as worms. |
|
#4
09-20-2002, 11:52 AM
|
||||
|
||||
|
__________________
"Three may keep a secret, if two are dead" ~ Benjamin Franklin ~ |
|
#5
09-23-2002, 06:50 AM
|
|||
|
|||
|
I just bought some at NAPA for a chevy 12 bolt, check there, they had many applications.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
