FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
|
SOLD Parts The parts in here have already been sold. The topics will be kept for a few months for reference. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
HSD Highly Modified Intake. Street or strip
I have a Highly Modified Holley Street Dominator Intake. Fully Ported with 1050 Flange. 1" spacer. Welded extended runners into plenum. Fully ported runners and plenum. Lower profile than a Victor gives the choice of fitting under stock hood. Port entrance is 2.320"x1.13". This same intake has gone 8 seconds in a 2600lb race car. Can be used on the street. I would recommend a head flow of at least 290cfm for this Intake to work well. Polished as well. Lots of hours in this Intake. 550.00.
|
#2
|
|||
|
|||
Hi Mike how are you? I am interested in this intake. I live in the Toronto area. I would use it on a 428 with 275 cam ram air II round ports.
|
#3
|
||||
|
||||
Nice work! Good luck with the sale!
|
#4
|
||||
|
||||
Adamo. PM Sent.
|
#5
|
||||
|
||||
This same Intake was 1 of Bob Maxey's custom design. He used this on his 8 second Grand Am back in the late 80's, early 90's. I have done more porting to the runners. It makes Great Torque. Welded extended runners. 1" welded Dominator spacer, plus the 1" on top. This is a very Nice Custom Intake. It could be used on the street. Head flow should be 290cfm of higher.
|
#6
|
||||
|
||||
This is Cheap HP for the Money. Great low end Torque. Bob Maxey ran 8's with this Intake back in the late 80's early 90's. Where can you get Bolt on HP for such a low Price!. Check the cost on stock Intakes New. This is a proven Piece. 1" spacer on top is removable. Great clearance for stock hoods. Take advantage of something that is a proven Combination. Head flow should be 290cfm or higher.
|
#7
|
||||
|
||||
Intake is SOLD !!! Merry Christmas.
|
|
|