| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
05-10-2012, 02:04 PM
|
||||
|
||||
Inspection Panel Fastner
I was wondering if anyone has a picture of the fastner setup for the dash inspection panel (under steering column). Also, does anyone know if anyone is reproducing these, or if there are other GM vehicles that also used the same part.
Thanks.
__________________
I built it one piece at a time and it cost me more than a dime. 
|
|
#2
05-10-2012, 02:37 PM
|
|||
|
|||
|
Pictures one and two are of the piece that sits in the lower metal channel of the dash (see picture four). There are two of these. Picture three is of the screw/fastener which goes through the hole in the lower inspection panel and into the piece shown in pictures one and two. There are two screws/fasteners as well.
|
|
#3
05-10-2012, 02:57 PM
|
||||
|
||||
|
Thank you! Now I what I am looking for. I might even have it in one of my misc. bolt boxes.
__________________
I built it one piece at a time and it cost me more than a dime.
|
|
#4
05-10-2012, 06:26 PM
|
||||
|
||||
|
PY sales them under part number RFI273. I just put my order in.
__________________
I built it one piece at a time and it cost me more than a dime.
|
|
#5
05-10-2012, 10:04 PM
|
|||
|
|||
|
I found this on Ebay.
http://www.ebay.com/itm/70-81-TRANS-...57780e&vxp=mtr |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
