| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
02-23-2021, 10:04 AM
|
||||
|
||||
Looking For Headers
Looking for headers that tuck up tight inside the frame rails. My new road racer project car is going to sit pretty low. What's everybody's experience?
I'm not sure what's on the car I bought but the left side tucks up and the right side hangs down way too much. 600-700 hp. Not sure yet whether D-port or round port. Eric
__________________
"Everybody has a plan until they get punched in the mouth" noted philosopher Mike Tyson Life begins at the end of your comfort zone. “The mind, once stretched by a new idea, never returns to its original dimensions.” |
|
#2
02-23-2021, 10:11 AM
|
|||
|
|||
|
although they can be a nightmare to get, tribal tubes are probably the tightest fitting headers for 2nd gens. the 1-7/8 should support your power level.
i have 2" round port hooker super comps on a 72 firebird that sits pretty low, they fit great but do hang down a little more than id like for such a low car. |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
