| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
03-24-2021, 07:34 AM
|
||||
|
||||
68 Bird rear axle bearing question
Folks,
I'm about to install new rear bearings on my axle shafts. Nothing on there for bearings at the moment, so clean to do this. I bought a pair of the Timken RW507CR bearings. These bearings look the same on both sides. Is there a front and back side, or doesn't it matter for installation? Yeah, I know, sounds obvious, but I don't want to start pressing and find out there's some sort of slight taper on the inner race that I've mucked up by doing it backwards. Thanks again for the help. OJ 
|
|
#2
03-24-2021, 08:22 AM
|
|||
|
|||
|
Either which way is fine on the sealed axle bearings like the RW507CR.
__________________
Buzzards gotta eat... same as worms. |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
