[mysticmissle]

68 dated block, been stored inside for long time will update on specifics after i pull heads off, currently has AIR 670s that will be available separately, can assemble a complete motor and sell as a runner if you require, with a variety of different heads, this block only has the 2 motor mount holes so it would need conversion mounts for anything new
Short block price is $200 will update if i turn it into a runner.

[mysticmissle]

found original distributor for motor, pulled it down to the crank as well. no cam, oil pump, lifters or timing chain included. all were new, unbroken in. im guessing it was out for a cam change and never went back in, maybe because they discovered the end play noted below.
an oil pan timing cover, valley pan will be included.
motor has +30 trw pistons, all bearings and journals look perfect, but crank end play is near +.030''
I have another crank i will include, i am not going to inspect to determine cause for extra end play at this time. AS stated no bearing material in pan, thrust bearing looks untouched. i can only assume bad crank grinding. Bearings have no oversized stamp and i did not measure
still see cross hatch in bores, but it was carboned up pretty good,
will sell pistons seperate, but would like to keep it together.
I may take some measurements if i get bored one day and see if it can be corrected with crank and bearings
sorry for the novel

[mysticmissle]

sold