| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
07-05-2008, 10:39 PM
|
|||
|
|||
Condenser screw
My car has a "uniset" point / condenser set in it. I want to replace it with a decent set of points and seperate condenser. Anyone know the specs for the condenser screw---size, thread, length, etc? Thought I'd ask rather than going trial and error over the distributor. Thx for any feedback.
Poncho60 |
|
#2
07-06-2008, 03:11 AM
|
||||
|
||||
|
I looked at an original from a late-fifties distributor. It's 8-32, .277" long, and has a .260" diameter slotted Fillister head. But, simply, any 1/4" long 8-32 screw will do.
__________________
Anybody else on this planet campaign a M/T hemi Pontiac for eleven seasons? ... or has built a record breaking DOHC hemi four cylinder Pontiac? ... or has driven a couple laps of Nuerburgring with Tri-Power Pontiac power?(back in 1967) |
|
#3
07-08-2008, 12:40 AM
|
|||
|
|||
|
you can buy distributor screws in Motor \ Help line of products in blister paks.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
