FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
||||
|
||||
Measurement needed RAIV firebird
I am wondering if anyone has a measurement from the carb top to bottom of the hood directly above the carb center stud .
I wondering if I could modify a lower pan to make the RAIV set up work with my dual quad RAV engine in my bird. Without the 2 inch spacers wig was originally raced with it sits approximately 2.75 below. Can’t measure mine cause the RAV is already in place. I could alter a fiberglass lower to gain a little if needed just wondering is if it’s at least close . A measurement to the upper pan would be ok too I could use my pan to judge the difference I know thise has been done w the RAV single 4 barrel but I want to do it w my dual quad V thanks .
__________________
Happiness is just a turbocharger away! 960 HP @ 11 psi, 9.70 at 146. Iron heads, iron stock 2 bolt block , stock crank, 9 years haven't even changed a spark plug! selling turbos and turbo related parts since 2005! |
#2
|
|||
|
|||
A repo TA hood without the upper pan will give you the most underhood room.Tom
|
#3
|
||||
|
||||
Thanks Tom but I want t run my stock RAIV hood w the RAIV pans. I just want to alter a glass lower pan for my dual quad RAV if that’s possible . Suppose I can dig out my RAIV intake and carb and measure to the top off the intake flange and compare w the dual quad RAV if no one has this measurement handy .
__________________
Happiness is just a turbocharger away! 960 HP @ 11 psi, 9.70 at 146. Iron heads, iron stock 2 bolt block , stock crank, 9 years haven't even changed a spark plug! selling turbos and turbo related parts since 2005! |
Reply |
|
|