[gpguy]

After Installing a Hood Tach in my 71 GP restomod, I found that the repro hood tach vent kit currently sold is not close enough to the factory pieces to even use for me. I've got NOS Filter for it but the fitting at the heater box in the kit was not an option. So I have designed and 3d printed my own reproduction of the heater box fitting. I've been designing for many years, think its close, had no oem part.
Had them service bureau SLS printed in a high performance thermoplastic. Can anyone give a review based on an actual part they may have? I can make these available if anyone else needs any. Overall length approx 1.25 inches, has the hole for the rivet etc. I'm also going to make my own reproduction filters just for fun.