FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
|
Performance Parts For Sale/Wanted Just Performance, non-stock, trailers, tools and related accessories here. |
Reply |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Cast Aluminum PONTIAC valve covers
Back up due to buyer who was confused and failed to read the previous ad.......
This is a set of the original valve covers sold by GM Parts direct. These will not fit with roller rockers. They have a set of thick gaskets from Indian adventures glued to them. Good condition. $150 OBO
__________________
************************************* 1968 Lemans. 37,000 original miles. GTO clone. 462ci/KRE 290 heads. UltraDyne 280/288 Solid/850 Qjet by Cliff/Performer RPM/TSP 9.5" in TH400/8.5" 3.42 gears/3950# Race weight/12.58@106 at Bandimere speedway high altitude |
#2
|
||||
|
||||
My covers fit with Crower Enduro rockers and thick gaskets. I am sure results may vary and big bulky aluminum rockers are unlikely to fit.
__________________
71 Formula 433, Splayed cap 400 block, 4" stroke Scat forged crank, 6.8 Eagle rods, custom Autotec pistons. SD 295 KRE D ports, Old faithful hybrid roller, Torker II, Holley Sniper Stealth, Tribal Tubes, TKO 600, 3.73 Eaton posi. |
#3
|
|||
|
|||
I run spacers, no problems.
|
#4
|
||||
|
||||
__________________
************************************* 1968 Lemans. 37,000 original miles. GTO clone. 462ci/KRE 290 heads. UltraDyne 280/288 Solid/850 Qjet by Cliff/Performer RPM/TSP 9.5" in TH400/8.5" 3.42 gears/3950# Race weight/12.58@106 at Bandimere speedway high altitude |
#5
|
|||
|
|||
The last ones I bought were on eBay. They’re cast but the outside was polished and look good. If I remember right they were 7/8 or 1” tall and only $50.00.
SD |
#6
|
|||
|
|||
Re: Spacers
|
Reply |
Thread Tools | |
Display Modes | |
|
|