[Jimbobeast]

Can someone post a photo of exactly where the ram air pull cable exits the firewall. I know it is below the windshield wiper motor, but exactly where. I see several dimples. Thanks.
Jim

[KGTO]

I literally just did this last night. The dimple is there but a little hard to see. I'll post a pic.

I found it by looking at the firewall dimple locations that was posted some time ago out of the service manual.

[KGTO]

Here ya go...I'd like to know what the hole between the harness clip and the throttle cable is for

Hope this helps.

Used a 27/64 bit and the grommet fit perfect.

BTW, I messaged you a while back about a console you had for sale

[KGTO]

Used a 27/64 bit and the grommet fit perfect.

BTW, I messaged you a while back about a console you had for sale

[Jimbobeast]

Perfect. What page in the service manual was that? It's too small to read and when I enlarge it, the image is too blurry. Is that the Fisher Body Service manual?
I have the same square hole. It must be used for something but I don't know what. I'll PM you abouth the consoles. I have two 4-speed consoles but they are in rough shape.
Thanks.

[Kenth]

Here are pics from the assembly manual:

[Jimbobeast]

I don't think my PM's are going through. You can have one or both consoles for the cost of shipping.

[KGTO]

I'm not getting notifications for some reason or I would have answered sooner. Looks like you got the info though. Thanks for the better pictures the bracket was a pain to do in the car bits its perfect.

[Jimbobeast]

Grommet and cable in place. I was looking in the wrong area. Thanks.