| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
10-17-2022, 03:57 PM
|
||||
|
||||
1967 GTO Tail Light Lens Assembly
I don't know if this has been asked before but is there any seal or gasket for the lens to the bezel?
All I can see is 4 screws (that I removed) but the lens was kind of 'stuck' in there. I wondered if a thin film of sealer would be advisable. I know there is a rubber gasket that goes between the tail lamp assembly and the body rear panel, I have a new pair of them.
__________________
1967 Pontiac GTO 1965 Olds Cutlass 2014 Ford Mustang ----------------------------------- GTO-The Great One for 1967 ----------------------------------- |
|
#2
10-29-2022, 11:02 AM
|
|||
|
|||
|
Hopefully someone will answer this good question! TTT
|
|
#3
10-29-2022, 12:59 PM
|
||||
|
||||
|
No, just an outer gasket is shown in the parts catalog illustration. I believe when it's compressed, it seals both the housing/lens (on the inside) and the housing to tail panel (on the outside).
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
