[Brian Baker]

Everybody seems to be out of stock of E-heads everywhere...except me. Get ready for this season with these.

Up for sale is a complete ready to bolt on pair of Edelbrock 72cc round port cylinder heads for a Pontiac. These were set-up for my blown alcohol funny car in 2006 but have never been run and are freshly pulled from the engine. Set up for a solid roller cam up to .750" net valve lift, specs are as follows:

New Ferrea 2.19/1.78 competition valves, new Comp 10 degree locks, new Comp 947-16 springs, new Comp 739-16 titanium retainers, new Comp seat cups, new guide seals, all machine work finished and ready to go with a competition port/polish to the intake and exhaust ports. Don't ask for a flow sheet, I have none, but these should flow in the 330-340 cfm range @ .700" lift conservatively.

Over $3800 in 2006 dollars invested, you couldn't duplicate these from new bare castings today for less than $5K.

$3500 with the T&D shaft rockers, $2600 without. Can ship in the original boxes they came in.

Check FB Marketplace ad link or pics below.

https://www.facebook.com/marketplace...ID=0&refType=0

[chiefbigb]

Pm sent

[62cat421sd]

do these heads require offset lifter on intake

[GTO Yea]

I'd be interested if chiefbigb doesn't take them.

[Brian Baker]

Heads are sold. T&D shaft rocker system is still available. chiefbigb has first refusal, followed by GTO Yea.

[GTO Yea]

I'm all set on the rocker system. Thanks anyway!