| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
05-22-2023, 12:05 PM
|
|||
|
|||
Hydraulic master cylinder question
Hey All, not sure the best place to put this, so here goes:
I put a T56 in my car and the master cylinder line hits my steering shaft. Do they make a 90 degree fitting for the end of this?
__________________
1968 GTO - 400/400 - Currently being rebuilt - 455/T56 1996 WS6 - LTI M6 - Sold 5/11 1979 Trans Am - 403/Auto - Sold 12/18 |
|
#2
05-24-2023, 09:45 AM
|
|||
|
|||
|
FYI in case anyone searches this thread looking for the same answer: The fitting type is called a quick disconnect, and McLeod makes a 90* fitting that turns in to an AN fitting. Just needed a new line with the AN fitting and I should be GTG.
https://www.summitracing.com/parts/MCL-139027
__________________
1968 GTO - 400/400 - Currently being rebuilt - 455/T56 1996 WS6 - LTI M6 - Sold 5/11 1979 Trans Am - 403/Auto - Sold 12/18 |
|
#3
05-24-2023, 11:59 AM
|
||||
|
||||
|
Thanks for posting the solution.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
