 |
|
| Pontiac - Boost Turbo, supercharged, Nitrous, EFI & other Power Adders discussed here. |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
|
#1
07-11-2011, 08:20 AM
|
||||
|
||||
Any interest in an EFI section?
I believe we have some EFI pontiacs around here. It seems that it would be good to have a section to adress the specifics of EFI conversions. Thanks
|
|
#2
07-11-2011, 03:33 PM
|
||||
|
||||
|
I would give a thumb's up to a section dedciated to EFI ! MFI (mechanical injection) is a good topic too
__________________
Knock Knock Knockin' on 11's Door '70 Judge, Palladium Silver w/Red Interior Powered by SD Performance, Ported 6X Heads 501 HP, 554 ft lbs TQ 12.14 ET @ 114 MPH , Supercase Muncie M22, 3:55 Suspension: HO Racing, BMR< Sykorat, and Bilsteins Narrowed 12 bolt , 16x8 VintageWheel Works, Comp T/As on street, MT Drag Radials @ Strip http://www.sdperformance.com/custome...1.php?carID=42 |
|
#3
07-11-2011, 04:46 PM
|
||||
|
||||
|
X2 for an EFI section.
|
|
#4
07-11-2011, 06:47 PM
|
||||
|
||||
|
I'm in too. Lot's of Pontiac guy's posting on Protouring. net board because they have a Fuel Injection forum.
__________________
Its ok to giggle and snicker, Dont laugh and point |
|
#5
07-12-2011, 03:45 AM
|
||||
|
||||
|
x3 for me also
__________________
24 beer in a case. 24 Hours in a day. Coincidence? I think not. " Steve Wright" |
|
#6
07-12-2011, 08:33 AM
|
|||
|
|||
|
I just installed the Fast XFI Multi port on my TA. I would like to see a EFI section.
|
|
#7
07-12-2011, 09:59 AM
|
|||
|
|||
|
I would also like to see an EFI section
|
|
#8
07-12-2011, 02:55 PM
|
|||
|
|||
|
efi
i am considering efi for my 67 gto post. i would love to see an efi forum
thanks bryan |
|
#9
07-12-2011, 03:57 PM
|
|||
|
|||
|
Add me to the list
__________________
1971 Trans Am - Sold 1977 Can Am - Sold 2002 Trans Am Firehawk - Sold 2004 GTO - Sold 2006 GTO - Sold 1970 GTO - Sold 1972 Trans Am - Sold 1970 Trans Am - Current Project |
|
#10
07-12-2011, 09:58 PM
|
|||
|
|||
|
I am in for an EFI section, especially with all the intake guru's we have on the forums.
__________________
Ben Mowery |
|
#11
07-13-2011, 03:27 PM
|
||||
|
||||
|
I have the fast system.. Would love to see an EFI section..
|
|
#12
07-13-2011, 04:01 PM
|
||||
|
||||
|
I'd love to have one of the FAST systems like their EZ EFI.
If santa claus brought me some hilborn injectors, I'd give santa a big hug
__________________
Knock Knock Knockin' on 11's Door '70 Judge, Palladium Silver w/Red Interior Powered by SD Performance, Ported 6X Heads 501 HP, 554 ft lbs TQ 12.14 ET @ 114 MPH , Supercase Muncie M22, 3:55 Suspension: HO Racing, BMR< Sykorat, and Bilsteins Narrowed 12 bolt , 16x8 VintageWheel Works, Comp T/As on street, MT Drag Radials @ Strip http://www.sdperformance.com/custome...1.php?carID=42 |
|
#13
07-14-2011, 10:13 AM
|
|||
|
|||
|
X4 going EFI
|
|
#14
11-18-2013, 11:41 PM
|
|||
|
|||
|
1X Cam Signal
Here is my version of a 1x cam signal for the Holley sequential port EFI. I started with a stub out from BOP, and made up the machined pieces to build up the extra length necessary to allow for a Hall effect sensor mounted vertically.
Inside there is a shutter type of wheel with a notch to give a “falling edge” trigger to the sensor. The pieces will be hard anodized after fit check. Note the cam drive gear is upside down in the photos. Motor is a 461 with Old Faithful HR cam (modified to 114 LSA), and KRE 305 CFM heads.  Hall effect sensor  Shutter wheel with cap removed  Cap inverted with sensor protruding through  Steel washers fabbed up to keep the distrubtor clamp from tearing up the soft aluminum   Mock up on the block 
__________________
1964 Catalina 2+2 4sp, 421 Tri-power 1965 GTO, Roadster Shop chassis, 461, Old Faithful cam, KRE heads 305 CFM, Holley EFI, DIS ignition. 1969 GTO 467, Edelbrock 325 CFM, Terminator EFI 1969 Firebird Convertible |
| The Following 2 Users Say Thank You to darbikrash For This Useful Post: | ||
|
#15
07-16-2011, 11:56 AM
|
|||
|
|||
|
I think its a great idea. Plenty of posts in Street/Race/Boost sections that could be compiled into one section. Some should be stickies. Who would want to moderate it???
|
|
#16
07-20-2011, 11:03 AM
|
||||
|
||||
|
What does a moderator have to do exactly?
|
|
#17
08-08-2011, 03:21 AM
|
|||
|
|||
|
An EFI section would be great since Im planning to convert my Lemans
|
|
#18
08-08-2011, 03:27 AM
|
|||
|
|||
|
An EFI section would be great since Im planning to convert my Lemans
|
|
#19
08-08-2011, 01:37 PM
|
|||
|
|||
|
+1 have a FAST EZ-EFI setup yet to go on the '72 GTO
|
|
#20
08-10-2011, 05:07 PM
|
||||
|
||||
|
I would bet that there are as many people interested in fuel injection as a separate category as there are interested in Boost/Forced induction
PY Mods, how many hands need to be raised in favor of a fuel injection section in order to make it happen ?
__________________
Knock Knock Knockin' on 11's Door '70 Judge, Palladium Silver w/Red Interior Powered by SD Performance, Ported 6X Heads 501 HP, 554 ft lbs TQ 12.14 ET @ 114 MPH , Supercase Muncie M22, 3:55 Suspension: HO Racing, BMR< Sykorat, and Bilsteins Narrowed 12 bolt , 16x8 VintageWheel Works, Comp T/As on street, MT Drag Radials @ Strip http://www.sdperformance.com/custome...1.php?carID=42 |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
