FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
||||
|
||||
Caltrac rear mount measurement
Quick question, anyone running caltracs can you please give me measurement on rear mount - bar bolt hole distance from flat part of plate. Basically how far down is rear hole
Thanks Eric |
#2
|
||||
|
||||
i have a set of moroso slide a links i can measure if that would help
__________________
1969 carousel red firebird 455, richmond 5 speed 1964 540 gto 1971 lemans sport convertible 1972 Maverick under slow construction |
#3
|
||||
|
||||
Sure thanks
|
#4
|
|||
|
|||
I can measure mine
__________________
466 Mike Voycey shortblock, 310cfm SD KRE heads, SD "OF 2.0 cam", torker 2 373 gears 3200 Continental Convertor best et 10.679/127.5/1.533 60ft 308 gears best et 10.76/125.64/1.5471 |
#5
|
|||
|
|||
On mine the centerline of the hole is about 3-1/4" to the bottom of the plate.
My set are quite old. https://calvertracing.com/product/mt-2-mount/ Information on line states the distance should be enough so that the rod should be able to miss the springs by at least 1". If it doesn't, these lower brackets will need to be a little longer. .
__________________
'70 TA / 505 cid / same engine but revised ( previous best 10.63 at 127.05 ) Old information here: http://www.hotrod.com/articles/0712p...tiac-trans-am/ Sponsor of the world's fastest Pontiac powered Ford Fairmont (engine) 5.14 at 140 mph (1/8 mile) , true 10.5 tire, stock type suspension https://www.youtube.com/watch?v=qDoJnIP3HgE Last edited by Steve C.; 03-19-2023 at 03:12 PM. |
#6
|
||||
|
||||
Thanks for info
|
Reply |
Thread Tools | |
Display Modes | |
|
|