FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
|||
|
|||
Driveshaft 1959 / 1960 center bearing
Is the driveshaft center bearing and support hardware the same for these years. I ass u me that it is----anyone know for sure? Thx for any feedback.
Randy |
#2
|
||||
|
||||
They are the same. Do you need a bearing ? I can give you NAPA part number...PM me for it if needed. Steele Rubber Products will re-vulcanize the rubber mount for you....about $100.00 + S&H. Saw a NOS support on Erape go for $225.00.......!!
__________________
ECM member. 2008 Outlaw Pontiac Drag Series Champion MANDRA Do it now fool! Life is short. 69 Grand Prix/3163lbs / IAII 535 w/ Tiger heads by Gaydosh....9.35@ 144 so far.. through mufflers. 1.26 60'. Going back to track with pump gas engine.... My 60 Ventura retired to street/strip duty.. |
#3
|
|||
|
|||
I looked at my service manual for 1960 and it shows how to remove and disassemble (sort of) the driveshaft and hanger bearing/support. Question tho----doesn't the rear section slide inside the spline of the front section? I assume that when the rear end moves up and down its front spline slides in and out of the rear spline of the front section. If that's the case, can't you just pull out the rear section without disassembling the hanger bearing/support? The reason I ask is that I bought a used driveshaft assy just to get the hanger bearing parts, and the seller would like to disassemble it for shipping. I originally asked to just send me the hanger bearing / support and to "can" the rest, but after looking at the shop manual thought I might learn something if I had the whole thing assembled---or at least partially assembled. Thx for any feedback.
Poncho60 |
#4
|
||||
|
||||
Quote:
Hope this helps some. You will wind up with this in your hand..LOL
__________________
ECM member. 2008 Outlaw Pontiac Drag Series Champion MANDRA Do it now fool! Life is short. 69 Grand Prix/3163lbs / IAII 535 w/ Tiger heads by Gaydosh....9.35@ 144 so far.. through mufflers. 1.26 60'. Going back to track with pump gas engine.... My 60 Ventura retired to street/strip duty.. |
#5
|
|||
|
|||
Does anyone know where I can find a new bearing AND support? Napa only sells the bearing w/o support
|
Reply |
|
|