| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
11-16-2021, 10:46 PM
|
||||
|
||||
Distributor question
I was cleaning up an original distributor and was wondering what this little rubber bushing does thanks
  Sent from my moto z3 using Tapatalk |
|
#2
11-17-2021, 12:44 AM
|
|||
|
|||
|
Advance limiter bushing
It's for limiting how much MECHANICAL advance the distributor will achieve.
Most of the aftermarket advance kits have a replacement bushing made out of brass. |
|
#3
11-19-2021, 10:13 PM
|
|||
|
|||
|
Forgot to mention
That's really a lot of grease.
Normally there is only grease on the outside of the mainshaft and the inside of the breaker cam assembly. I don't know if it would make a difference, but it could sling grease all over the inside of the cap it there is too much. Good luck! |
|
#4
11-20-2021, 12:34 PM
|
||||
|
||||
|
Quote:
I would also think about how much dirt is going to stick.
__________________
1978 Black & Gold T/A [complete 70 Ram Air III (carb to pan) PQ and 12 bolt], fully loaded, deluxe, WS6, T-Top car - 1972 Formula 455HO Ram Air numbers matching Julep Green - 1971 T/A 455, 320 CFM Eheads, RP cam, Doug's headers, Fuel injection, TKX 5 Spd. 12 Bolt 3.73, 4 wheel disc. All A/C cars |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
